Operation precautions of CNC slotting machine

CNC grooving machine is mainly used for grooving operation when dealing with cracked asphalt and cement pavement lesions. Irregular cracks are formed by 6 special leaves
The irregular cracks are arranged into uniform grooves by 6 special leaves to form a new joint. The contact layer between the filling material and the groove is optimized, and the tightness between the filling material and the side wall of the seam is enhanced.

The tightness of the filling material to the wall is enhanced. In order to better use the CNC grooving machine, the following is to understand the operating precautions of the CNC grooving machine.

First, before the machine starts, you must carefully check whether the cutting tools, nuts and screws are reliable. If found loose, must be timely
tighten.

Second, when installing the tool to pay attention to the cutting direction, do not reverse.

Third, the main tool clockwise rotation.

Four, before opening the feed, make sure the pneumatic device in the movable push table and positioning plate to open and press the workpiece, and do not allow the hand
close to the cutting edge.

Fifth, when the machine fails, should cut off the power, stop operation, and send someone to repair and adjust.

Sixth, before processing, the material should be checked on the tool whether there are nails, sand and stone joints.

Seven, machine tool cleaning, lubricating oil cleaning, saw blade and knife debris, etc. must be cut off the power supply to the machine tool.

Eight, the machine should be the appropriate personnel to operate, adjust and maintain, not familiar with the machine tool is strictly prohibited to use.

Nine, workers should wear ear plugs, glasses and other supplies when operating.

Ten, the maintenance of the machine should be in accordance with the "equipment operation, maintenance and maintenance system 'for.